Martin-audio CS10 Manuel d'utilisateur télécharger pdf (Page 7)

The subwoofer grille may be positioned so that it visually replaces a

ceiling tile in a suspended ceiling but, we repeat - the subwoofer

must not rely on the suspended ceiling structure for its support.

Hint: It is easier to install your CS10 above a suspended ceiling

structure if you temporarily remove surrounding ceiling tiles for better

access and light.

We must repeat; threaded rods or eyebolts must be

permanently attached to the brackets provided using aircraft

style locking nuts so that they cannot loosen under vibration.

Do not simply hang this product from “hooks” as it could

escape from them when driven with low frequency signals at

high volume.

If height adjustment is required, we recommend that you use locking

adjustment nuts either side of the three brackets or turnbuckles

(200Kg rating) between the building structure and the CS10

brackets.

Anti-vibration gasket strip (supplied) may be placed around the edge

of the grille for a snug fit without vibration.

Connections

Amplifier power input is via a 4-pin rising clamp plug providing

+ and – Inputs and + and – Loop Through connections.

The CS10 input and loop connector must be fireproofed using the

steel cover and screws provided. This cover has a 19mm (0.75”)

knockout and a clamped cable entry.

1 2 3 4 5 6 7 8 9 10 11 12 13

Pas de commentaire

Martin-audio CS10 Manuel d'utilisateur Page 7